![]() #Synology vpn monitor manualYou cannot use this option in combination with manual Vertical Axis Scaling (available in the channel settings ). This generates a graph that visualizes the different components of your total traffic. Stack channels on top of each other : Stack channels on top of each other to create a multi-channel graph.Show channels independently (default) : Show a graph for each channel.You can set a different primary channel later by clicking below a channel gauge on the sensor's Overview tab.ĭefine how different channels are shown for this sensor: The available options depend on what channels are available for this sensor. In the device tree, the last value of the primary channel is always displayed below the sensor's name. Select a channel from the list to define it as the primary channel. ![]() For some sensors, you can explicitly define the monitoring target in the sensor settings. Usually, a sensor connects to the IP Address/DNS Name of the parent device. Choose from the lowest priority ( ) to the highest priority ( ). The highest priority is at the top of a list. This setting determines the position of the sensor in lists. The sensor has the following default tags that are automatically predefined in the sensor's settings when you add the sensor: #Synology vpn monitor plusIt is not possible to enter tags with a leading plus ( +) or minus ( -) sign, nor tags with parentheses ( ()) or angle brackets ( ).įor performance reasons, it can take some minutes until you can filter for new tags that you added. You can use tags to group objects and use tag-filtered views later on. Confirm each tag with the Spacebar key, a comma, or the Enter key. You cannot change it.Įnter one or more tags. This setting is for your information only. Shows tags that the sensor inherits from its parent device, parent group, and parent probe. The settings that you select in the Add Sensor dialog are valid for all sensors that you create when you finish the dialog. You can change nearly all settings on the sensor's Settings tab after creation. It only shows the settings that are required to create the sensor. The Add Sensor dialog appears when you manually add a new sensor to a device. You can change the behavior of a channel by editing the lookup file that the channel uses. This means that possible states are defined in a lookup file. This sensor uses lookups to determine the status values of one or more channels.This sensor has a very low performance impact.This sensor supports the IPv6 protocol.Simplified Chinese : SNMP Synology 物理磁盘. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |